I wrote a T-N-T about that a couple of years ago. It was designed as a hands-on tutorial that was a little confusing.
If you jog to position, whether it is jog to center or jog to edge (or is it corner?), you need to consider the 3.5" for support.
If you place on corner (not jog), it will position the virtual board on the end of the real board if you DO NOT tell it to stay under the rollers.
If you tell it to stay under the rollers, it moves the virtual board down the length of the real board 3.5".
I think that is what I wrote back then, I have not done much carving in the past couple of years, and no Jog to position.
Last edited by DocWheeler; 03-29-2014 at 02:47 PM.
Ken,
V-1, 2, & 3
When the People fear their Government, there is Tyranny.
When the Government fears the People, there is Liberty.
- Thomas Jefferson
You must be the change you wish to see in the world.
- Mohandas Gandhi