Johnsonswamp How did you fix it? I have the same problem on my 2nd machine I bought used. The plastic where the screw went in broke off.
Johnsonswamp How did you fix it? I have the same problem on my 2nd machine I bought used. The plastic where the screw went in broke off.
I'll take a picture tomorrow for you. But I took a piece of I think it was 1/4 angle iron I had laying around, drilled 2 holes through it and the open side of the bottom where dust falls through and bolted it against the rod with small bolts an nuts. Looks rigged up but works perfectly, and a whole lot cheaper and easier than replacing the whole bottom. Just gotta clean/grease it from time to time, but i have dust collection and have yet to have dust build up on it.
Thank you
mav36