Glad that you figured it out and all is good again ...
Glad that you figured it out and all is good again ...
Mans Quest for knowledge,,, means he'll always find a way !!
Well, my "Y" rails are apparently dirty again. I put a 4hr 13min carve project on the machine. The project consisted of four separate carves, one each for each side of a box I'm trying to make. Three "sides" carved just fine, on the last one, I got the dirty "Y" rails message. I checked the rails and they were quite clean. I started the machine back up and the machine forgot where it was and carved all the way to the edge of the board. The last (4th) side was a square carve region, 3/8" deep with an elephant within. 3/4 of the elephant was done when the error message came up.
Any new ideas??
I could also be one or more of the Y bearings.
RingNeckBlues
My patterns on the Depot
DC-INSERT It Just Sucks!
Proven to out perform all others!
Buy CarveWright
Colorado FaceBook Users Group
All patterns and projects that I share on the CarveWright forum are for your personal carving purpose. They are not to be shared, sold or posted on any other web site without permission from RingNeckBlues Designs.