I am still on 1.150. The place tabs icon stays greyed out. I placed a pattern in a carved out region and tried pierce, undid that and tried making the carved out area .75 deep. Either way, I can't use the place tabs. How do you do it?
Clint
I am still on 1.150. The place tabs icon stays greyed out. I placed a pattern in a carved out region and tried pierce, undid that and tried making the carved out area .75 deep. Either way, I can't use the place tabs. How do you do it?
Clint
Draw a line across the pattern and pierced cutout. With the line selected, the Tabs icon will light up.
Rob
That was easy - thanks
Clint
Thank you this helped me
Just tried it, but I must not have something just right because I don't see the tabs...
Strike that - played with it and see them hiding there
Last edited by chief2007; 05-02-2012 at 04:53 PM.