i finnaly installed the new version of the soft ware and did a carve of the pattern it came out good . am going to try to do a bigger one soon i hope . thank you for the time amd effert you have takeing in to helping me with this . its not finnished yet but heres what i have sofar
version-1.175 Desk Top
version-1.176 Lap Top
Help ! I can't tell where I am . Its's dark and I can hear laughing .
here is a pattern for a Wind Harp I got off the Shop Smith site it is free. They sound neat whenb the wind blows though them
Hello Everybody,
Does, anyone have patterns of a full size M-1, M-16 or M-14, two sided carve. I am new at this, but would like to carve the one saw in pattern sharing depot. Hope some one help with project.
Smooth4
Dirtydan
A.K.A. The Gunny
Every day I thank God for Mister Levi Strauss
mailto:gunny@thegunnys.us
http://www.thegunnys.us
See if this works....... let me know......
JerryB:.
CarveWright START U Team Member
Using 1.187, Conform, PE/Probe, Centerline.
"Let's start sharing PTNs instead of MPCs so ALL SW versions can view & share"
Maybe someone could work with this and make it a 2 sided carve. Don't know where I picked these mpc's up, but found them while out surfing around.
JerryB:.
CarveWright START U Team Member
Using 1.187, Conform, PE/Probe, Centerline.
"Let's start sharing PTNs instead of MPCs so ALL SW versions can view & share"
Dan,
Very Nice!
Thanks for the file,
I promise to put it to good use.
Last edited by Kenm810; 10-28-2009 at 07:37 PM.
Ken
Ver 1.182 on XL Pro plus Ver 1.164 and 1.175 on Windows 7 Ultimate
It Never Fails * Till * You Say It Never Fails
Dan, thanks for the patterns
Ken great use of the pattern