I can not seem to locate this in my paper work I have seen it but don't know where. How can I correct this so I can complete my project?
I can not seem to locate this in my paper work I have seen it but don't know where. How can I correct this so I can complete my project?
usually I clear this by a blast of air from my compressor under the truck where the board sensors are. You can also wipe it with a soft cloth or soft brush. also look at the link below that says carvewright troubleshooting and error guide.
Page 12 of the troubleshooting guide
http://www.carvewright.com/2010CWweb...ting_Guide.pdf
Machine works fine now THANK YOU all for the help. I know there are problems you people have seen a lot from us newbis.
And we do thank you for not getting upset at us. In time we to will learn and pass it on. Jim
To test, white copy paper cranked down on it and use options to look at the numbers on the LCD. 156 is perfect.... 90 is a dirty lens.
AL
Favorite Saying.... "It's ALL About the Brass Roller"..... And "Use MASKING TAPE" for board skipping in the X or breaking bits.
Follow ME on Facebook http://www.facebook.com/pages/Accoun...50019051727074
www.PoconoDigitalWoodshop.com
www.AccountabilityTag.com