I like to make the Design Drawing and then make a font from the drawings. And then use Centerline to mark the design pattern on the carving board;(MPC file) this gives you a frame guide to place the pin holes. I like to use my air drills to make the pin holes; a dermal tool would also work. If you don't want the design frame - you can remove that after all the holes are marked. The CW unit can also drill all the holes if it does not mess up
Last edited by bjbethke; 03-04-2017 at 03:46 PM.
Using Designer Version 1.187
Donations are always welcomed, thanks – send a check to my PO Box 652
BJB
PO Box 652
Yellville,AR 72687-0652
PM me for my e-mail address.