Page 4 of 4 FirstFirst ... 234
Results 31 to 33 of 33

Thread: Z axis stall: E06-0313, board thickness

  1. #31

    Default

    Thanks guys, it's the QC. I looked at the bit adapters again and it looks like there is the beginning of one indention on the adapter. I also think the Y gear or bearings are shot as I slid the Y/Z carriage to the center and it was grinding this time. Is there a major advantage of one chuck over the other? It looks like the Rock is easier to swap out. Thanks again for all of your advice/help.

    Thanks
    Bill
    Hobby Central

  2. #32
    Join Date
    Aug 2008
    Location
    The Great Texas Gulf Coast
    Posts
    5,314

    Default

    Here's a link to the CarveTight Installation video

    http://www.carvewright.com/support-p...vetight-video/



    Sent from my iPhone using Tapatalk
    CarveWright CX Packaged System - starting at $2000
    CarversClub 1 Year Subscription - $150.00/year
    Adv. Support w/out CC membership - $25.00/issue
    CarveWright Community Forum - PRICELESS!

  3. #33

    Thumbs up

    thanks all. I was having a z stall issue as well..I looked at the new bits I just received against the old ones and noticed that the old ones were seated differently and therefore longer. I sat the replacement bit lower and the z stall issue was cured.

Page 4 of 4 FirstFirst ... 234

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •