Originally Posted by
MikeA
I have followed all the tips on this forum including calling in yesterday. It appears I'm not getting any voltage to the Z or Y servor motor as well as the X motor (moved the motors around and I can not feel any resistences). Trace cables and ohm them all out back to the controller cable end. So my limited technical troubleshooting skills is tell me that I could have a bad controller or bad power supply.
Question on the power suppy: I have 5 DC volts on V1 pin on the power supply connector, but no reading on V2 pin. Should I have maybe a 12 DC volts out on V2 pin that feed the motors, or the entire Carvewright machine works out of the 5 volts?
Thanks in advance for any help on this poblem.