Think it was KenM that posted a chest top for a small box, this is what I did with it, thanks KenM
Junior Member
Another box
Think it was KenM that posted a chest top for a small box, this is what I did with it, thanks KenM
Senior Member
Yep, I remember that thread. Your box is great, good work.
In Memoriam
Great Job, The credit is all yours, Well Done!
Ken
Ver 1.182 on XL Pro plus Ver 1.164 and 1.175 on Windows 7 Ultimate
It Never Fails * Till * You Say It Never Fails
Senior Member
Really nice to see one of my patterns carved (belt).
Great job
Last edited by eelamb; 01-29-2011 at 09:19 PM.
Using Designer 1.187, STL importer, Center line, conforming vectors, scanning probe/PE, and the ROCK chuck.
Eddie
Junior Member
I am inspired. When I get my problem worked out I think I have a new project to try. Thanks for sharing
Senior Member
A very nice box. Especially like the travel decals....it adds a lot to your box.
In Memoriam
Excellent job, very beautifull. I love it
Hilda
Senior Member
Nice! Can you provide some construction details? How about posting the project?
Senior Member
Peter that is excellent! I would love to make a box like you made! Maybe Ken can share the mpc again? Again well done and I love you carved all the places to show where you have been!
Ike
Last edited by Ike; 01-30-2011 at 10:57 AM.
Senior Member
That turned out really nice, good job.
CJ
CarverJerry
ver. 1.188 Win 7- 64b with 6 GB ram @ 2.8Ghz and dual 1Tb hard drives. Rock Chuck & Ringneck vacuum system hooked up to a Harbor Freight large vacuum. Center line text, conforming vectors.
Reply With Quote
