Angel Wings -- Here's a set -- I tipped them downward,
meaning their adjustable, you can combine them anyway you wish
Angel Wings -- Here's a set -- I tipped them downward,
meaning their adjustable, you can combine them anyway you wish
Last edited by Kenm810; 04-13-2012 at 04:30 PM.
Ken
Ver 1.182 on XL Pro plus Ver 1.164 and 1.175 on Windows 7 Ultimate
It Never Fails * Till * You Say It Never Fails
Thanks Ken, I'll run this past her and see what see thinks.
Here is a cross MPC I made a few ago with star points.
Last edited by liquidguitars; 01-28-2011 at 02:28 PM.
Doves and the Sprigs of Olive Leaves
Last edited by Kenm810; 04-13-2012 at 11:33 AM.
Ken
Ver 1.182 on XL Pro plus Ver 1.164 and 1.175 on Windows 7 Ultimate
It Never Fails * Till * You Say It Never Fails
Tom Watson
Two CW's and D.C.-Top Mount Insert @ Ringneckblues.com Get the dust out!!
50" X 48" PDJ Pilot Pro CNC http://www.pdjinc.com
Check out my Facebook page for current carvings at http://www.facebook.com/signsinwood
Watsons Wooden Words http://www.signsinwood.com & Messages in Wood http://www.messagesinwood.com/
Celtic Symbols and Patterns have always been kind of Inspirational to me,
so I suppose this is a pretty good place to Post this one.
Last edited by Kenm810; 04-13-2012 at 11:34 AM.
Ken
Ver 1.182 on XL Pro plus Ver 1.164 and 1.175 on Windows 7 Ultimate
It Never Fails * Till * You Say It Never Fails
I have been working on a pattern, and thought I was done with it, but noticed one of the angled sides on the 5 point is missing on the bottom. Will have to figure this out. But here are a couple of images of the Luther Rose I have been working on. Sometime in the next day or so I will fit it and have the pattern ready.
Using Designer 1.187, STL importer, Center line, conforming vectors, scanning probe/PE, and the ROCK chuck.
Eddie
nice looking Eddie...I see your getting the "dips" now
I should mention I was in a block, had blinders on as they say and John lead me to the solution for the curved areas. Thanks John. And here is the finished pattern. I will have the pattern on my website later on.
I took the background off of this one.
Using Designer 1.187, STL importer, Center line, conforming vectors, scanning probe/PE, and the ROCK chuck.
Eddie
Eddie,
Looking good!!
RingNeckBlues
My patterns on the Depot
DC-INSERT It Just Sucks!
Proven to out perform all others!
Buy CarveWright
Colorado FaceBook Users Group
All patterns and projects that I share on the CarveWright forum are for your personal carving purpose. They are not to be shared, sold or posted on any other web site without permission from RingNeckBlues Designs.