[QUOTE=twiceretired;132332]Of the Version C improvements, which ones can we order to improve our working machine?
I know we can order the Carve Tight Spindle System, but what about the other improvements? Will they work on our present 2 year old machine, I think Version B
• CarveTight Spindle System
• Base Reinforcements
• Vertical Guide Rod Stabilizer Feet
• Reinforced Strapping on Power Supply
• Modified Board Tracking Sensor
• Simplified X Gear Drive
• Software and Firmware Improvements
I don't think we will know until they come out with a new Parts list and part numbers for the "C" unit. I only can fine the one for the "B" unit.
If the cable Plugs and Jacks fit the new power supply they may work if only the strapping was improved.
I would think the new Board tracking sensor should work.
For around $500.00 plus dollars I think they will improve the old units.
I just replaced some of CW parts in my old “B” model, ordered from sears the part numbers are in the LHR “Parts PDF”, and the CarveTight Spindle System I ordered from LHR. I’m hopping it will last me another two years.
I removed the “Y” truck the first time and found this is the best way to replace the board sensor – I found the cable gets damaged trying to do that while attached to the machine.
On the Base Reinforcements and the Simplified X Gear Drive I would think that would depend on if they made a new casting for the base, the new Z-Truck has a new casting.
Hope this helps.
Using Designer Version 1.187
Donations are always welcomed, thanks – send a check to my PO Box 652
BJB
PO Box 652
Yellville,AR 72687-0652
PM me for my e-mail address.