Circles in circles

[rwahl]

I want to have a number if circles of various radius with the same center but differant depths. Anyway to do it?

[dbfletcher]

I want to have a number if circles of various radius with the same center but differant depths. Anyway to do it?

Sure.. just draw your circles and apply a carve region to each circle at the depth that you want.

Doug Fletcher

[rwahl]

I have 5 circles all as regions. All at different depths but they all show up as the same depth.

[dbfletcher]

I have 5 circles all as regions. All at different depths but they all show up as the same depth.

I think i see the issue.. it depends on if the inner ones are higher or lower than the outer ones. I'm working on a smaple mpc to post in a few.. unless someone else beats me to it.

Doug Fletcher

[spalted]

Merging and clipping is the secret, but I'm not adept enough at it yet to explain it. I don't have it all figured out yet.

There was a tips & tricks pdf or two that helps some.

[dbfletcher]

Ok.. maybe this will help... im sure it can be simplified from what i have.

Doug Fletcher

[rwahl]

Thanks, thats close.

But I want the outside circle and center circle to be lower than the
second circle.

[dbfletcher]

more like this right side now??

[rwahl]

You da man.
Now if I can just follow how you did it.

[dbfletcher]

You da man.
Now if I can just follow how you did it.

I'll be honest... it was more just "clicking" for me than actually knowing what i was doing!

Doug Fletcher