The way I look at it. If it wasn't for the Proprietary software the machine would not work at all. Therefore no one would use it. Therefore, no one would buy it. Therefore the company would be bust. I've worked in the IT sector for long enough to know that if you can't have quality, you need more tech support.
Haven't had any problems with 1.161 . Was kind of hoping they would have added a few second delay between the bit change and the time it goes to touch over the board tracking assembly. I am about to run out of epoxy. Sure like the new way of checking and maintaining the board tracking. I had a gui crash when I tried to save a new scan but it worked on the second try. I feel like CW is a good company. And wish to thank them for the great job they are doing to keep us informed and up to
date. THANK YOU CW
http://william.bowen.com/:)
("There is a principle which is a bar against all information, which is proof against all arguments and which cannot fail to keep a man in everlasting ignorance-that principle is contempt prior to investigation."
- Herbert Spencer )
I haven’t had any issues with 1.161, but I’m not a heavy user. I think LHR does a very good job, and should be commended for all the enhancements’. How long has windows 7 been out, and already 17 updates, and there just trying to run a computer.
Ok, heres a picture of the bad text. It was weird to watch it. It carved the G and I fine, but cut off the right edge of the B. Then it moved over to start an S did 4 or 5 passes then lifted the bit and reversed to be over the right edge of the B and started carving backward, moved over to start an O and did it backwards again then the same for the N. I can see this as a brass roller issue as it has happened before but this is the first time I have seen it move backward while carving a letter.. wonder if its repeatable ....
Do you have rubber belts on your unit?
LG
No I have the original sandpaper belts, I really have to try to make it repeatable though, the board isn't slipping, the belts are running backwards when those letters were being carved. That is instead of standing at the keypad and watching the board move left to right (as viewed) it ran right to left
AskBud Downloads =>> CLICK HERE
Lesson added 7/15/2012 Titles begin with "2D-3D Build a Pattern-Part-3"
CW Vacuum Head Project =>> CLICK HERE
AskBud Home Page =>> CLICK HERE <<=PC lessons or CW lessons
More than 1250 AskBud patterns vvv-CLICK BELOW-vvv
http://store.carvewright.com/manufac...ufacturerid=29
I've already redone it to get a single copy of the project to run correctly, if it is a repeatable error I will post an MPC and steps that cause an error