Results 1 to 4 of 4

Thread: cutting the corners off a board

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. Default cutting the corners off a board

    I am sure there is an easy way to do this and I am doing it the hard way (I usually do lol )

    I want to have a cutpath that will take off the corners of the board to make it a little fancier than just leaving square corners. In the mpc the board is 36 X 12, the actual board will be 43 X 13 to allow the compression rollers to stay on the board .... I have GOT to build a sled one of these days, this wasted wood is killing me .... so if you could look at the mpc and tell me how that should have been drawn or if it should cut out as I have it. Would it have been necessary to draw the path manually instead of using a circle and rectangle like I did?

    Thanks for looking and any advice on getting it to cut the way I want it to.
    Attached Files Attached Files

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •