i am trying to calibrate my belts and when it finishes measuring and cutting the notches i measure my board and enter my measurements and it gives an error saying Calibration range error.?
i am trying to calibrate my belts and when it finishes measuring and cutting the notches i measure my board and enter my measurements and it gives an error saying Calibration range error.?
Last edited by mrstevens26; 12-28-2009 at 05:32 PM.
Do you put masking tape on the under side of the board (nearest the keyboard) if not try it !
If you get a error it could be you just added the wrong measurement.
you will need to do it a few times until you get it right I think.
also you can put non decimal measurements in like 30 1/2" instead of 30.50"
LG
Last edited by liquidguitars; 01-01-2010 at 02:02 PM.