Originally Posted by
bobtom
I have the same problem. Replaced the belts and the belt in the front (with the display on the left} tore half way thru the project. any help would be greatly appreciated.
Can't find any thing causing this. Would the rubber belts help? I have a set here but don't want to put them on while I have the tearing problem. Help please.
You said tore, so is it on the glued line separating? Did the corner of a board snag it? May just be old glue or head pressure is too high (with sandpaper belts should be 70-80).
When you put your heavy duty belts on, your head pressure should be 80-90. These won't tear or roll up, but you do need to keep the HP between 80 & 90.
CarveWright CX Packaged System - starting at $2000
CarversClub 1 Year Subscription - $150.00/year
Adv. Support w/out CC membership - $25.00/issue
CarveWright Community Forum - PRICELESS!