I have a complete setup that I need to sell quickly. If it's OK, I'll post details.
Thanks,
Jon
I have a complete setup that I need to sell quickly. If it's OK, I'll post details.
Thanks,
Jon
Yes it is OK to post it for sale here just don't post phone number because the mod's will delete it. What ya got? Where is it located?
Hi Dan -
I'm in Moses Lake WA - 100 miles west of Spokane.
I have the CompuCarve with box, manuals, etc. I've used it less than 4 hours total. I also have the probe - never used, and the bit set, most of those never used either, and the centerline text option for the software along with the subscription patterns from last year.
Our dog was just diagnosed with cancer and I need to raise funds to pay for surgery. Since I never seem to find time to use this, it's the logical thing to go.
Thanks,
Jon
Sorry to hear about your Dog Jon, went through that last year.
Regarding your sale, be aware that the Centerline and Purchased patterns are not transferable. Also if the Probe was registered, it will also not transfer.
Good Luck on the sale, and prayers for your Dog.
If it doesn't fit force it. If it breaks then it needed replacing anyway.
Have a Craftsman Carver and Running Ver. 1.150
Posting pictures tutorial http://www.malanoski.com/downloads/posting_pictures.pdf.
Thanks. I wasn't aware of the non-transfer on the software & patterns. I'm pretty confident I never registered the probe though since I haven't used it.
Jon
Last edited by bjbethke; 10-30-2009 at 01:11 AM.
Using Designer Version 1.187
Donations are always welcomed, thanks – send a check to my PO Box 652
BJB
PO Box 652
Yellville,AR 72687-0652
PM me for my e-mail address.