-
I hope it is a cupped board, I have had my machine do this and it was the Z motor. I had to replace the motor. I may be wrong but I had to check the plastic gears. Anyway if you are under warranty give CW a call.
Ike
-
Hello Gean,
I was looking at your pix real close and it does look like corrupt lines of logic in your upload, I have not seen this happen before, but it is possible. I would Format the firmware card and flash machine code 1.153 in flash manager then up load the project again next I would turn the board over and carve the back side if it is not cupped that is and give it a go hate to waste a nice piece of Oak.
Let us know how it turns out.
Ray
-
Redo
Ray,
I deleted it from my memory card, reloaded the whole thing into the designer software and then to the memory card. It's carving as I type this. The oak is actually three pieces that I planed and glued together. The grain matches so well that you can hardly tell that it isn't one large board. Will let everyone know how it carves.
Gean
-
Success!
Carved the JOY Tree after reloading it onto the memory card and it came out fine. I even used the backside of the oak board. Thanks for all your suggestions!
Gean
-
Gean,
Glad to hear you got it done. I have 2 carved that sanded up real nice - I hope to be able to play with getting some stain on them today....but we shall see what the honey do list looks like
Craig
-
Hi Gean,
To cool, Thanks for getting back to us, with a learning experience and success story.
I have also carved the Joy tree and working on the finish I hope to see yours and Craig’s Posted here.
Good day ~ Ray
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules