Thanks for sharing this Robert. A couple of times I have had a "fatal errer: please reboot machine" due a small static discharge after vacuuming during the carve. I always try to stay grounded when the vac is running, but sometimes it doesn't work. Anyhoo....each time that has happened, I did as you suggested and the carve pretty much took off right where it left off. On one carve, there was some discrepency, but with a little time and a lot of Dremel work, I was able to save the carve. I can attest that this will work.
Richard
If things improve with age, then I am
approaching MAGNIFICENT!!
Using v.1.170