Error message when compiling project

[trplbogie]

Has anyone ever gotten the error 24 when project was compiling to the card?
I tried 2 uploads of basically the same pattern but one would load the other gets the error message. And of course it is the one I would like to do first.

[fwharris]

does it give you any other info with the error 24???

[trplbogie]

yeah it says it's sorry. Contact LHR for support or fix. At least it apologized

[fwharris]

apologies are nice some times!!!

If your mpc does not have any purchased patterns you can post it so maybe we can take a look at to see what might be causing it..

[trplbogie]

It has Univ of Bama Logo, but it is Alumni logo and I have alumni permission to use If this is the one with the cutouts it is the correct one

[fwharris]

I got the same error 24 uploading as is. Then I changed the bamaround merge to normal (unfortunately that is not what you want it to look like) and it uploaded just fine.

I reset everything back to the original settings then changed the height of the bamaround to 100 (was 400) and it uploaded with out the error..

So it must have been that height setting that caused error.

[trplbogie]

Thanks again

[PCW]

I resized it and it loaded on the card and if you remove the unnamed file it will load as-is.

[fwharris]

Doc,

That is one question I can not answer! I was trying to figure out why it went so deep myself. There are still a lot of things to learn/figure out!


EDIT: Doc, you deleted your post????

[DocWheeler]

Floyd,

After writing it, I went back into the mpc and messed with the "Subtractive/Additive" and found that with Subtractive that the Height setting affected the Depth and assumed that it was just something that I had not yet learned!