any suggestions on how to stop this from happening this is number 4 of these cables. one that came on the machine one LHR replaced and two I have replaced the one shown is last one replaced at factory while under warranty
Thanks
any suggestions on how to stop this from happening this is number 4 of these cables. one that came on the machine one LHR replaced and two I have replaced the one shown is last one replaced at factory while under warranty
Thanks
"Our principles are the springs of our actions. Our actions, the springs of our happiness or misery. Too much care, therefore, cannot be taken in forming our principles." Red Skelton
I have 1.132 and previous versions back to 1.19 on standby
Please support Cystic Fibrosis
You could add a strip of rubber tape to both sides of the cable after it is in the holder to place the bend point out further and hopefully is gentler.
AL
Favorite Saying.... "It's ALL About the Brass Roller"..... And "Use MASKING TAPE" for board skipping in the X or breaking bits.
Follow ME on Facebook http://www.facebook.com/pages/Accoun...50019051727074
www.PoconoDigitalWoodshop.com
www.AccountabilityTag.com
also would this break cause the z axis errors 298 and 308
"Our principles are the springs of our actions. Our actions, the springs of our happiness or misery. Too much care, therefore, cannot be taken in forming our principles." Red Skelton
I have 1.132 and previous versions back to 1.19 on standby
Please support Cystic Fibrosis
It looks like the ribbon is twisted. This might cause too much stress at the end. I think the ribbon should be vertical.
Cable should be level..... If too high, then added stress can snap the wires....
Yes, that can cause a Z Error code.
AL
Favorite Saying.... "It's ALL About the Brass Roller"..... And "Use MASKING TAPE" for board skipping in the X or breaking bits.
Follow ME on Facebook http://www.facebook.com/pages/Accoun...50019051727074
www.PoconoDigitalWoodshop.com
www.AccountabilityTag.com
There is how it was when I opened the cover. First time top has been off since last time it was in shop for them to repair z bundle and some other things
"Our principles are the springs of our actions. Our actions, the springs of our happiness or misery. Too much care, therefore, cannot be taken in forming our principles." Red Skelton
I have 1.132 and previous versions back to 1.19 on standby
Please support Cystic Fibrosis