Originally Posted by
jpitz31
I am doing a recessed carve from a pattern I created.
The depth of cut is .25, the height is 999, I want the top of the of the pattern even with the work surface. I have a medium draft angle set.
Carve region is not set.
The pattern cuts just fine. But the entire region of the pattern is .007 recessed from the work surface. The tool cut path cuts the entire pattern shape and recesses the whole pattern shape.
Any ideas on how to keep pattern at the work surface level?
Thanks
Joe
it is saying 999, 999 is not the top can you sand it down to make it work???
Using Designer Version 1.187
Donations are always welcomed, thanks – send a check to my PO Box 652
BJB
PO Box 652
Yellville,AR 72687-0652
PM me for my e-mail address.