Search:

I have a carvewright machine for sale. Original box. Last time I used it (over a year ago), I was getting an error - something about the flex shaft - I think it was error number 12, but am not...

Thanks Alex,

I tried it both ways and it didn't seem to make any difference.

Steve

OK Finally got around to trying this out. Between Work, Fire Fighting and EMS I manage to stay pretty busy.

I performed the sensor data check. I had the chuck in about the middle of the travel...

Thanks, Al.

I won't be able to get to this until the weekend. Mrs. 13Z5M has me pretty busy until Sunday afternoon.

I'll try the suggestions and post again on Monday.

Thanks again,
...

I tried that - both the screws were very tight. Put the machine back together and tested - I am still getting the same error. Any other ideas?

Thanks - I'll try it after work.

Steve

Can someone please describe the location of the two screws I am looking for?

Steve

Hi,

I am getting an error "Homing problem z axis". I did a search and found a solution to pull the z pack and tighten two screws. according to LiquidGuitars...

"you could check the screws.....

It doesn't seem to make any noise or move at all. I've done all the cleaning recommended by other threads and have removed the bottom and the side panel and do not see anything obvious. There was a...

Hi,

I've read all the threads about X axis stalling and am trying to debug my problem. My question is...should I be able to move the sandpaper belts by hand? I cannot do this and I think the...

Hi,

Moved to troubleshooting area.

Thanks,

Steve

I left a message yesterday...no return call. I left another message today...so far, no return call.

Steve

I had the same problem this morning, but couldn't figure out which forum to post a message. Thanks.

Steve

Try this link. It has lots of info on making manual cut paths.

Steve

Nuke the baby seals!!

Steve

The way I remember it is...

Although you'll find our house a mess,
Come in, sit down, converse.
It doesn't always look like this,
Somedays it's even worse.


My mother had it over the...

Here's a Fire Department Maltese Cross if anyone can use it.

Steve

Thanks for the hints everyone. I combined all of them - and my wife's suggestion to make it a little bigger on the wood - and it looks much better. Thanks.

Steve

Hi,

Once again I return to the well of knowledge hoping to quench my ignorance.

I have what I think is a pretty good PTN file. When I save it and then import it to use in designer, it...

You are right. I did it backwards - which is why it worked. Thanks.

Steve

That did it. Thanks!

Steve

No, Is that what I am doing wrong? I'll give it a try.

Steve

Hi,

I am trying to design a disk with three different carve depths. The wood thickness is .750". The outside ring would be .250" deep, the middle one .350", and the center .500.

I created...

Hi,

I replaced the gear tonight. Kind of a pain, and it took an hour and a half, but I am back up and running!! Ran a few test pieces through and am looking forward to doing some serious stuff...

Got to believe what newcarver said. I use http://www.freebyte.com/fbbackup/ religiously after losing a hard drive - and three years of work.

Steve