Search:

I bought one of these machines when they first came out at Sears. It has been so long ago that I can't remember the date. I used it and every 2or 3 hrs. of use it broke down. I finally got 12 hrs on...

How about this one?

I am experiencing the same thing with my CW. It starts out fine and part way thru the carving the bit raises a little on each pass until it is above the board.

I read your message about dust in...

Jon
I would like to say thanks too for your time, patterns and the excellent training video's. They are better that regular CorelDraw video's because yours show us exactly what is needed to make...

Brad

I too had some problems with my drive belts. The left one wandered toward the front of the CW and was rolling under itself.

When I took it off I was amazed to see how thin of material the...

Here is a pic of the Grandfather clock that I built before I got CW. I am noiw using CW to cut out wooden gears for my next clock. I got most of the gears cut now but CW is giving me an Yaxis 236...

Mine work fine now too...

Thanks very much for great Corel setup info.

wally

Jon,

That sure is a great job for sure. I haven't attained the skill to do that in Corel yet.

After seeing pics of your wrench, I would like to make a similiar sign for a friend of mine. He is...

Charles,

The things that I look for in a pattern is the outline of the gears. If they can be scanned and easily cleaned up so that you only have the outline of the gear left. I also look at the...

Charles,

The things that I look for in a pattern is the outline of the gears. If they can be scanned and easily cleaned up so that you only have the outline of the gear left. I also look at the...

Charles

I checked out your link, I think those would be difficult to produce, especially for your first project.

I see that there is a very nice looking plan for a wooden Gear Clock on the...

Hi BenCraig

I have got most of the clock parts made now, but my wife wants a new floor in the dining room, 2 bedrooms and hallway. So I have been doing that in my spare time. Got one bedroom done....

Sorry I forgot to include that once you place and center the gear in Designer, you then set the size of gear by placing size in size boxes above gear.
Then proceed
Wally

I make wooden clock gears with CW. I start with a paper plan of the gear and scan it and save it as a gif file. Use Photoshop and zoom in and make sure that the outline of the gear is continous. If...

Thanks Bob.

With a few more gears under my belt, I am well on my way to making a wooden clock

Wally

Can you make woodgears with the CarveWright, I will use 1/4" plywood.

Yes I just finished making my first gear out of 1/4" Baltic Birch plywood. I started from paper plans and scanned them into...

I got it fixed. Talked with the guys at CW and he showed me where the Homing sensor was and all I had to do was blow it out with air and all was fine.

Thanks

Wally

New CW with approx 5 hrs operating time.

After I install my board and select my project from the memory card, I get an error ...Please Check Homing Sensor...

After I press END it says ...Y/Z...

I just received my CW today and I installed the full version of the software. Registered it and all. I did a small test carve and worked fine, just a bit louder than I expected.

In the demo...