I use sticky shelving paper before the carve, spray the letters and sand off any bleed thru. Greg
Type: Posts; User: gsdsj; Keyword(s):
I use sticky shelving paper before the carve, spray the letters and sand off any bleed thru. Greg
67348
Here is Eddie's converted dxf to mpc. Greg
This has been happening to me, also on a Mac. Greg
no sweat, the more the merrier!
here's one I made
66779
Connie, thanks for your honesty and hopefully some relief in 2.005. I would be more than willing to run any tests with the Rock and working
on a Mac if you need assistance. Greg
Okay, so finally someone from LHR says it's a "problem" with the Rock. So again I ponder why it was not disclosed the CT was a requirement to 2.0 or mentioned in the FAQs?
I already own 2.0 and...
I am sure there members like me that lurk in the background for info on this forum, read several times a day sucking up as much info as I can. Rarely post 70 something posts
since 2008. So how many...
I have never had any problems with the Rock, all my bits have functioned properly thru 1.87. As soon as I installed 2.0 the bits zoomed across the rail and flew down deeply into the bit plate. It's...
I with Steve, as I have already purchased 2.004 around Thanksgiving. There was no mention of it would only work with the CT in the description of 2.004 or the FAQs. As for the Maverick thing, I'm...
Doug check your private messages. Greg
Thanks, I'll give it a try.
I have the same question in regards to the standard size 1/16" carving bit and the 1/8" cutting bit. What is the distance from the tip of the bit to the bit plate?
The same question as to the v90...
This glitch with OS 10.9 and the fact that 2.0 doesn't seem to like the Rock Chuck would have been nice to know before I bought it.
In centerline you cannot set the depth, scroll over the lettering and it will show the depth at the bottom left of the screen.
I have used an 1/8th 22 degree vbit for fine lines. Used the setting as if it were the carving bit in designer, from there you could set the depth. I was more worried about the speed and feed rate....
Lawrence, your pattern making is outstanding and helping out Capt. Bruce will diffidently get you some Karma points. You stated in your post "You should just be able to carve it x2 and then put...
your video is marked private
Will this work? Greg
62465
Can't find it on Rocklers, but here's a link at Baileys.
http://www.baileysonline.com/itemdetail.asp?item=16501&catID=
Kevin the jig I bought from Rockler came with the bit. It's the same setup that Al posted the video of. Greg
Kevin I have the jig Al mentioned, works great. That, some forstner bits, some logs or branches and imagination your set to go.
Greg
Either of these work for you. Greg
60946
60947
PM me with your email address, can't seem to attach in a PM. Greg
FYI your PM quota is maxed out.
Looks like you might chipout problems around the edge of the top tab. I cleaned the edges up on this one, give it a try.