thanks for the help. the analog led us in the wrong direction. exact problem. I have just put in the machine a shape that looks like a cake pan with sides 1/2 " high, now I am trying to carve a...
Type: Posts; User: lviele; Keyword(s):
thanks for the help. the analog led us in the wrong direction. exact problem. I have just put in the machine a shape that looks like a cake pan with sides 1/2 " high, now I am trying to carve a...
assume we have a sled and the wall is one inch high as measured from the surfice of the sled. can I carve a surfice 1/2 down from the top of the rails? I can curve a pattern 1/4 down but no more. Am...
on the bit selection there is an option called insert what does it di its not in the help menu
check woodworkers supply for ruter bits got one of freud 1/8" bits and it works fine
I have seen several notes about corean , where do you get is, can you get it in 1/4"?
I will second the comments about a cold shop, It takes a while for the machin to warm up, so even if you have turned the heat on it will take some time
for the sensor,I had the same problem until I...
I did a carving of delicate arch in aeches NM I needed to use a photo editing feature to change the photo the game is to lighten the section you want to carve and darken the section you want to...
woodworkers supply has a good list of freudbits including a 1/8 spirol bit for around $19
After sending you my comments on sears bits I went out to the shop and checked, the sears bits are carbitei
purchased some bits from sears, they are freud bits and I would bet dollars to donuts thats where carvewrigt gets them. woodworkers supply has the bits, be sure to look at the spiral bits, the 1/8"...
so what am I doing wrong, seeing you know all about bits thought you might help. carved out seveal patterns with no problem. I then tried to put a1/8" wide by 1/4" deep slot around a pattern....
seems you know something about sleds so maby you can help.
1.I select a board for the sled say 3/4 12x12,call it the sled
2.I select a 1/4" board to put a pattern on, call it the board
3.I glue...
Found one problem, by downloading new drivers from dell it fixed som of the problem but it is still there
I copied a photo to favorates and selected this for a carving, it worked well.I tried it again with a different photo and now selecting the icon causing the screen to go blank. even deleating the...