Board runs threw during measurement issue
I've had a rash of issues with my machine lately that are starting to really discourage me and this latest issue has got me stumped.
I had to replace the plastic gears for the belt drive assembly. Well I got that done and put the rubber belts on during the process.
Now I've had a new issue after getting it all together.
When I put a board in and tell it to measure the board it's running the board threw past the rollers then give an error.
I was kind of thinking that the little tracking roller might not be turning but it is. wasn't sure if the sensor that's under the cutting head measured that but it's measuring the width so I would think that would be working.
What would cause this new issue all of a sudden?
I took the top cover back off and checked the small circuit board back there blew out the terminals but no help.
Seems odd that the board tracker was working before but just stopped unless I severed a wire or something during reassembly but I was pretty careful during all of this.
Am I missing something that someone else has experienced?
Any help would be appreciated I really am becoming disheartened with all of this at this point I nearly have a new machine and think I could have saved money had I just bought a new one my hobby is getting expensive.
Thanks