2 Attachment(s)
Question about Sled and two sided Carve
I have made a sled and made a nice plaque for a family member. I would like to see about just flipping the board over and doing it again to have the plaque two sided. Attached is pictures of the sled ( I only have the one picture, but I did change it so the cut board is centered)Attachment 67392
and a picture of the project. Attachment 67393
The deepest cut is .250 and the board is .75 thick, so I'm pretty sure that I have the thickness to cut it twice.
One concern would be making sure that I have the bottom on the same side so if it was hanging one side wouldn't be upside down, I believe I have that figured out from the TIPS and TRICKS on Sleds. But a comment to re-assure my thoughts are correct will be helpful.
My second concern would be making the board to thin, where it isn't strong enough to be durable. I believe the wood is African Mahogany, it was part of a "gift" pack from a friend.
I'm sure this has been done before by someone else. Seems pretty simple to me, just hate to scrap a decent project that I am almost ready to say is complete.
Thanks for all the great help you guys provide.
Steve