2 axis stall ERR. E06-0313
Hi everyone
got this 2 axis stall err. message trying to cut some oak and not sure whats going on. has anyone got this message before? any ideas on why? was just wondering my shop has no heat in it right now and don't know if the cold has an effect on performance? Thanks in advance.
Roger
2 axis stall ERR. E06-0313
I was cutting a recess in a oak board .250" deep and about half way through the machine quit and displayed 2 axis stall. so I took the board out and replaced it with a pine board and it cut it out fine. put the oak board back in and same thing as soon as it started to cut it stopped. I replaced the two tractions belts thinking (one had a small tear) that might have something to do with it but it did the same thing a few min ago. Should have heat in shop this weekend..
Quote:
Originally Posted by
bergerud
Welcome to the forum. I have never heard of the 2 axis stall. I would think that one stall caused the other. What was the machine doing when the stall happened? Did the board slip? Is the bit dull? We would need some more info if we are to try and figure out what happened.