Another machine for sale - Sears "A" with upgrades

I bought a second machine a few years age when I really needed
to finish a project for a granddaughter shortly after her father died.

I paniced and bought a re-built machine before finding that it was just a
bad version of firmware.

It has not been used in about four years - 153 carve hours, 375 "on" hours.
It was updated by LHR with the newer 14 conductor cable - Z bundle.

It has a "balanced" QC that worked well for me - (Rock on newer machine).
It has a hole on the "muffler" as many machines do; I have a sock over it.

Only the basic two bits, card, card-reader, and QC release tool are included.
But, that is all that was included with it.
I'll throw in a bunch of bit adapters for the QC, including a 1/8th inch one.

Asking $500 plus shipping, Waynesville Ohio. PM me.

The machine shipped out today.

I wish to thank all of those that showed an interest.