I 'm getting A Z-Axis Stsll Err EO6-0303. Made 7 of the same then started to get this??
Anyone??
Printable View
I 'm getting A Z-Axis Stsll Err EO6-0303. Made 7 of the same then started to get this??
Anyone??
check your bearing probably binding
It goes to 59% then stops
Does anything special happen at 59%? Like, does the carve go deeper or wider?
No the error just comes up
yes it stops at same place
I would try reformatting the card and refresher the firmware. It you were running the same project back to back the card might of been corrupted.
Have you tried reformating and reflashing the card? Do you have a DC system? Have you moved the z truck up and down to see if there is a rough spot?