Here are some of the projects I have used to learn about the software and hardware.
Al
Printable View
Here are some of the projects I have used to learn about the software and hardware.
Al
Why dont you put those in the share section , Great work
Tom
Super nice job on the projects, keep up the excellant work.
I am a new guy and therefore you can assume that I know very little about the CarveWright system - I am attempting to convert an *.mpg to a *.mpc that can be recognized by CarveWright as a valid pattern - I can load the *.mpg into the pattern editor but cannot go further, so I cannot upload to the flashcard where the pattern can be carved - It appears that you have accomplished this so I would appreciate an assist on this matter -
Thanks from exgenius
I am having difficulty changing an imported *.mpg into a *.mpc that can be uploaded tobe carved - I would appreciate any assistance you can render -
Thanks
exGenius
An .mpg file is an audio file, has nothing to do with the CW. Do you mean a PNG file? If you have loaded the file into the pattern editor you need to save it as a pattern file to your library. Then you create a new project in Designer, open the library, place you pattern, etc.
Take a look at the tutorials the CW has provided: http://www.carvewright.com/cms/tutorials, that should help get you started.
Alexa,
The projects look great. Did you buy some of the patterns that you used?
Alexa looks like you are a learning quite well great looking projects,
If that's your "learning" work Alexa, I'd say you're well on your way!! Keep it up!
Hey Guys,
Look at the dates. The original post was almost 2 months ago.