See my first 2 pictures on the other post. The Board Sensor just sits in a slot then held by 2 screws. For your sensor, I would just hold it in place from the back with a piece of DUCT TAPE... until you need a new sensor.
Printable View
Thanks Al! Your explanations help a lot.
I took the Y Truck off... Even snapped a screw as seen in the pictures.... But I wondered if I could do then butt Floss Trick... un hook the board sensor. Un hook the top plug. TUG the wire UP to dislodge the pinch. Then pull down and up, seeing if you feel it free.... Worth a try....
AL
Air shipment of parts should be here this week. Hopefully, customs won't hold them up.
Just as I took apart the old sensor and cleaned it and glued it back together, I got an email from Carvewright saying my order has shipped. Haha, go figure. i'm just going to wait the week till the part comes in to get back to carving.